Add to Favourites. Add page 1 to Favourites. Enable zoom. Stop the wake function: Press OFF. The wake function will activate again on the following day at the same time. The set wake time will not be erased and can be used the next time when you switch on wake function again. Setting clock1. Press or to set the clock time. The time decrements or increments will follow by a faster rate when you press and hold the buttons. AM or PM indicator also lights beside the time on the display. RP RPR v6.
Battery back-up operationThe power failure protection circuit will not operate unless battery is installed. No worry battery backup When the battery backup functions, the digital display will not light, however, the wake function still occurs during the power interruption if remaining battery power is adequate. Normal operation will resume after AC power is restored so you will not have to reset the time or wake. Rotating the unit slightly may improve reception of distant AM stations.
Setting wake time1. Press or to set the wake time. Selecting wake source1. You can set the duration up to 90 min before the radio or CD player turns off automatically. You may change to listen to the CD player by pressing if a disc is loaded. Carbon- zinc battery may be used but memory holding time will be substantially reduced.
Memory holding time for a fresh alkaline battery is approximately 8 hours if radio or alarm are not operated which should take care of short, nuisance-type AC power failures. To preserve battery life, the unit should remain plugged into an AC outlet. As the battery gets older, its voltage drops and memory may be lost. Be sure to replace the battery periodically.
Battery should be removed if the unit will be stored for more than one month. Leaky battery can badly damage the clock radio. For your recordsIn the event that service should be required, you may need the model number and the serial number.
In the space below, record the date and place of purchase and the serial number: Model No. For instructions on how to obtain service, refer to the warranty included in this user manual. Lift open the CD compartment door. Insert a disc and close the door. Press to select CD mode and start CD playback. Adjust volume to your desired level.
Press or to skip backward or forward a track. Press and hold to search through a track. Press to stop playback. After AC power is restored reconnected , the Digital Display will blink to indicate that power was interrupted and you should readjust the time and alarm settings.
The power cord picks up moderate to strong stations and eliminates the need for an external antenna in most strong signal areas. Be sure the power cord is stretched out to its full length. Do not coil or bunch the cord together. Changing position of the power cord may improve reception. It helps reducing drift on FM reception and keeping the radio locked in on the FM station to which it is tuned.
When tuning in FM stations, you may notice that the station you are tuning can be well-tuned on two or three nearby points on the dial. RADIO — turn on the radio. REV — set clock or wake time decrease value. FWD — set clock or wake time increase value.
OFF — turn off the unit. DST — turn daylight saving function on or off. The time decrements or increments will follow by a faster rate when you press and hold the buttons.
AM or PM icon will also show beside the time. US time zones Auto clock setYou do not have to set the clock time as a built-in automatic time set system is equipped in this clock powered by 2 AA batteries included and installed. To set the clock time correctly: 1. The default time zone is Eastern EST refer to the maps on the right. Your clock is now set and ready for use. It helps reducing drift on FM reception and keeping the radio locked in on the FM station to which it is tuned.
When tuning in FM stations, you may notice that the station you are tuning can be well-tuned on two or three nearby points on the dial. Always tune carefully at the loudest and clearest point. AM antennaA built-in ferrite rod antenna eliminates the need for an outside antenna for AM reception. Rotating the unit slightly may improve reception of distant AM stations. Setting wake timeThis unit allows two wake times to be set. Selecting wake sourceYou may be woken up by radio or alarm.
Set a wake time see above direction. The wake alarm or radio will be switched off temporarily. The alarm or radio will be on again when the snooze period default: 9 minutes is over. The wake alarm or radio will activate again the next day unless you switch off the Wake function. Snooze function can be used repeatedly up to 60 minutes. After this, the wake function will turn off until the next day. In sleep mode, you can set the duration up to 90 minutes before the radio turn off automatically.
Sleep function Audiovox Electronics Corp. To obtain repair or replacement within the terms of this Warranty, the product is to be delivered with proof of warranty coverage e. This Warranty is in lieu of all other express warranties or liabilities. No person or representative is authorized to assume for the Company any liability other than expressed herein in connection with the sale of this product.
Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damage so the above limitations or exclusions may not apply to you. If applicable, before shipping a product, make a back up copy of content or data stored on the device. Also, it is advisable to remove any personal content which you would not want exposed to others.
Product will be returned with factory default settings, and without any pre-loaded content which may have been installed in the originally purchased products. Consumer will be responsible for reloading data and content. Consumer will be responsible to restore any personal preference settings.
Include any remotes, memory cards, cables, etc. However DO NOT return any removable batteries, even if batteries were included with the original purchase. We recommend using the original carton and packing materials. Also print your name and address and a description of the defect.
0コメント